top of page

Home / Lab / Handle size

Tennis grip size: chart and calculator

Measure your hand, enter your racquet's size and do the index-finger test: the tool cross-checks them and gives your size on the L0–L5 scale, in inches and millimetres. The explanations follow the tool.

The grip size chart, L0 to L5

Grip size is the circumference of the handle, measured halfway along it, over the original grip. Each size is one eighth of an inch, about 3.2 mm: L0 is 4 inches, 101.6 mm, and the scale climbs to L5. The European notation gives the letter, the American one gives the inches directly.

L0 4″ 101.6 mm · L1 4 1/8″ 104.8 mm · L2 4 1/4″ 108.0 mm

L3 4 3/8″ 111.1 mm · L4 4 1/2″ 114.3 mm · L5 4 5/8″ 117.5 mm

The scale only describes a circumference. It says nothing about the shape of the section, which is why two handles of the same size do not sit the same way in the hand. Two traps: some brands number from 1 what others call L0, a one-size shift; and a handle stripped back, or regripped with a thinner grip, no longer has the size printed on its butt cap. Go by the inches, and on a used racquet, measure rather than trust the label.

The two measurements the tool cross-checks

Hand length. Open hand, fingers together and straight: measure from the middle crease of the palm to the tip of the ring finger. The value in millimetres reads on the same scale: 108 mm falls on L2. That is how the rule was built, and it is also its limit, because it ignores the thickness of the hand and the length of the fingers.

The index-finger test. Hold your racquet in a forehand grip and slide the index finger of your other hand into the gap between your fingertips and the base of your thumb. A snug fit means the size is consistent; no room means the handle is small; room to spare means it is big. Do it again in a backhand grip: if the two verdicts differ, your hand sits between two sizes.

Between two sizes, take the smaller

Too small, and you squeeze harder so the handle does not turn on an off-centre hit; that grip force comes from the forearm muscles, whose tendons attach at the elbow. Too big, and the hand cannot close: wrist mobility at the end of the swing and the speed of grip changes both suffer.

Material can always be added, never removed: one overgrip adds about half a size, two add about one. What an overgrip does not change is the shape. It rounds off the bevels your fingers read your grips by, and a worn overgrip has already lost part of its thickness.

Frequently asked questions

Is L2 the same as 4 1/4?

Yes. L2 is the European notation and 4 1/4 inches the American one, for the same circumference, 108 mm. The only trap is brands that start counting at 1: check the inches printed on the butt cap.

Does an overgrip change my grip size?

By about half a size, depending on its thickness, and two overgrips add about one. It also wears: a racquet set to the right size with a fresh overgrip becomes too small again after a few weeks, with nothing else having changed.

What if my two measurements disagree?

It is not a measuring error: your hand does not fall exactly into the grid, and moving up or down one size will not solve it. That is the case a custom handle is made for: it fits any racquet, and it can be replaced if you were one size off.

Further reading

Your hand, your handle

Tennis grip size: how to measure it, and why measuring isn’t enough

Handle

Tennis grip size: how to measure it, and why measuring isn’t enough

Read the article
The custom handle: the only part your hand actually touches

Handle

The custom handle: the only part your hand actually touches

Read the article
How to choose a tennis racquet? Start with four numbers

Choosing

How to choose a tennis racquet? Start with four numbers

Read the article
bottom of page