top of page

The sweet spot: what forty years of measurements really say

5 days ago
9 min read

Updated: 11 hours ago

The ball leaves, the arm receives nothing, it almost feels as if you never touched it. Every player knows that shot. We call it the sweet spot, as if it were one precise place on the string bed.

The physicists and biomechanists who have measured it since the late 1970s do not say quite the same thing. Nor do they contradict each other. Put side by side, their results tell a coherent story, more useful than a dot on a diagram: what you call the sweet spot is several phenomena meeting at a place that depends on your racquet, your hand and the shot you play.

One word, four phenomena

The vibration node. When struck, a racquet vibrates like a beam: the frame flexes a hundred to nearly two hundred times a second, depending on its stiffness. Two points stay still, one in the handle, the other near the centre of the string bed. A ball struck on that second point barely excites the vibration.

The centre of percussion. An impact pushes the racquet back and rotates it at the same time. For one particular impact point, the two motions cancel where you hold the handle: the hand receives no net jolt.

The point of maximum rebound. This is where the ball leaves fastest. On a stationary racquet it sits towards the throat, where the frame's mass is closest. When the racquet is swung it moves up, because the head travels faster than the throat.

The dead spot. Near the top of the head, the racquet "weighs" so little to the ball that a ball dropped there barely bounces. It is where the frame's effective mass falls to that of the ball.

Howard Brody, the physicist who first put these points into equations, was already distinguishing them in the early 1980s. None of them coincides with another. That is the starting point for everything that follows.

What eight studies measured


Study

What was measured

What it establishes

Hatze, 1976

Impact forces and duration, tight or loose grip

A tight grip passes more impulse to the ball, and more shock to the hand.

Brody, 1979 to 1997

Rebound and vibration on free and hand-held racquets

During impact, a hand-held racquet behaves almost like a free one. Several distinct sweet spots.

Hennig et al., 1992

Vibration at wrist and elbow, 23 racquets

Off-centre, acceleration at the arm is about three times higher. The higher the frame's frequency and the larger the head, the less the arm receives.

Cross, 1998

Forces actually received by the hand, hand-held racquet

No point removes the load on the hand. The most comfortable zone lies between the node and the centre of percussion.

Li et al., 2004

Frame vibration reaching the forearm, with and without a damper

The damper does not change the frame vibration that reaches the forearm.

Allen et al., 2011

Simulated impacts across the whole string bed

Away from the node, a stiffer frame returns the ball faster. Mass and balance act through swing speed.

Choppin et al., 2011

106 shots by 16 ranked players, filmed in 3D

On the forehand, high-level players aim for the node.

Ikenaga et al., 2020

Forehands by intermediate players, impacts below, at and above centre

A few centimetres of difference do not change ball speed, but they change the face angle and the effort of the wrist muscles.


Where they agree

Comfort is a band, not a point. Cross instrumented hand-held racquets and measured what reaches the palm. On the node, the vibrational component disappears under the hand. On the centre of percussion, the forces on the top and bottom of the hand balance out and the forearm barely moves. Between the two, the energy passed to the handle is lowest. On a typical racquet this band is a few centimetres wide and surrounds the centre of the string bed.

No point removes everything. Even at the best spot, a torque turns the hand around the wrist. The impulse reaches the handle in about a millisecond and a half, while the ball stays on the strings for several. The sweet spot reduces the load; it does not erase it.

Outside the band, frame vibration travels up the arm. Hennig and colleagues measured about three times more acceleration at the wrist for off-centre impacts. It fades towards the elbow, but it gets there. Two frame properties reduce it: a higher natural frequency, meaning a stiffer frame, and a larger head. The grip matters too: Hatze had already shown that a tight hand passes more impulse to the ball, and takes more shock.

The best players aim for the node. Shots filmed at a tournament by Choppin and colleagues show that high-level forehands look for that spot. It is no accident: that is where the feel is cleanest, and so where the information reaching the hand is most reliable.

Where they differ, and why

Brody held that during impact a hand-held racquet behaves like a free one. Cross showed that the hand and forearm already influence the racquet while the ball is still on the strings, since the impulse reaches the handle before the ball leaves.

Both are right, each for his own question. For ball speed, the free model describes the essentials: the hand has no time to add much effective mass at the impact point. For what you feel, the hand changes everything. It damps vibration far better than any accessory, and it moves the axis of rotation. As measured by Cross, that axis sits four or five centimetres from the butt end. And held in the hand, the racquet turns about an axis slightly ahead of the butt end, which moves its centre of percussion up towards the centre of the string bed.

The practical consequence: the position of the centre of percussion is not a property of the racquet alone. It depends on the axis the racquet turns about, and so on the hand. Saying it sits "five centimetres below centre" only makes sense for a given racquet, held in a given way.

The fastest ball is not at the sweet spot

The point of maximum rebound depends on the shot. On a blocked return, the racquet barely moves and the ball comes in fast: the frame's mass sends the ball back, and the best spot moves down towards the throat. On a full swing, head speed takes over and the point moves up towards the centre.

In the module, for the example racquet, the fastest point sits 12 cm below centre on a blocked return, 7 cm below centre on a groundstroke, and practically at the centre on the serve. These positions come from a simplified model. What matters is their order, and one more property: around the centre, the speed curve is almost flat. On a groundstroke, hitting the centre rather than the fastest point costs about 2% of speed.

That is exactly what Ikenaga's team measured: a few centimetres of difference on the string bed do not change ball speed. They change the face angle and the effort of the wrist. In other words, a few centimetres matter far more to the arm and to direction than to power.

What the frame decides

The centre of percussion can be calculated

The node depends on how mass and stiffness are spread through the whole frame; a setup moves it little. The centre of percussion, on the other hand, follows directly from three measurable figures: mass, balance and swingweight.

For rotation about the butt end, its distance from the butt is:

Centre of percussion (cm) = 980.5 ÷ MGR/I

with MGR/I = ((Mass/1000) × 980.5 × Balance) / (SW + (20 × (Mass/1000) × Balance) − (Mass/10)).

MGR/I, which tells you whether a racquet "arrives on time", and the centre of percussion are two readings of one ratio between the frame's weight and its inertia.

For a pivot other than the butt end, the general formula brings in a value the blog already uses: recoilweight. The centre of percussion sits RW ÷ (mass × distance from pivot to centre of mass) above the centre of mass. The higher the recoilweight, the higher it sits.

Example racquet: MGR/I = 20.56, centre of percussion 47.7 cm from the butt, 2.6 cm below the centre of the string bed. With a pivot at 5 cm, as measured in the hand, it moves to 50.5 cm. The node sits around 53.1 cm. The comfort band therefore spans 5.5 cm, either side of the centre. Cross found, on his test racquet, a centre of percussion 5 cm below centre: same order, same direction.

What lead tape does to it


Setup

Mass

Balance

SW

MGR/I

Centre of percussion

Stock

320 g

32.5 cm

320

20.56

47.7 cm

8 g at 12 o'clock

328 g

33.4 cm

347

20.14

48.7 cm

8 g in the handle

328 g

31.8 cm

320

20.60

47.6 cm

4 g at 3 and 9 o'clock

324 g

32.7 cm

326

20.54

47.7 cm


  • Lead at the top moves the zone up by about one centimetre for eight grams. That is modest, and it is honest: a setup does not move the sweet spot to the other end of the head.

  • Lead in the handle barely moves it, but it makes the racquet easier to swing: MGR/I goes up.

  • Lead at 3 and 9 o'clock does not move it. It widens it sideways: twistweight goes from 14 to 14.7, and a ball struck left or right of the axis turns the frame less in the hand.

Stiffness and the damper

Contact lasts about five milliseconds. A frame that vibrates fast, around 180 Hz, completes almost a full cycle in that time: the ball excites it less than a flexible frame at 100 Hz. That is the mechanism behind the correlation Hennig measured between natural frequency and arm vibration. Stiffness has other costs, on contact time and on the arm; the 69 RA article covers them.

The damper acts on string vibration, not frame vibration. Li and colleagues found no difference in the frame vibration reaching the forearm, with or without one. It changes the sound of the hit. It does not change where the sweet spot is.

An area does not say what the arm feels

The sweet spot is often presented as an area, in square centimetres, that grows with head size. That simplification measures the wrong thing. What the arm feels depends on the distance between the impact point and a band whose position is set by the frame's mass, balance and swingweight, and by the hand that holds it. Two racquets with the same head size can place that band two centimetres apart. A player who naturally hits high will not find comfort on the one that places it low. The useful question is not "how big is the sweet spot", but "where is it, and where do I hit".

Explore the sweet spot

The module below applies all of the above to your racquet. You enter its mass, balance, swingweight and twistweight, then tap the string bed to hit. It also has a page of its own: explore the sweet spot.

  • The string bed map places the node, the centre of percussion, the comfort band between them and the point where the ball leaves fastest for the chosen shot. Beside it, three profiles show, along the whole head, handle shock, frame vibration and ball speed.

  • The slow-motion animation shows the racquet from the side at impact: recoil, rotation, frame vibration, and the direction in which the handle moves in the hand. Hit at the tip, then the centre, then towards the throat: the handle moves forward, barely moves, then is pushed into the palm.

  • The settings add lead at 12 o'clock, at 3 and 9 or in the handle, change frame frequency and the pivot position in the hand, and switch between a blocked return, a groundstroke and a serve. Every change redraws the map.



What it changes on court

  • Record your impact point. A little powder or chalk on the strings, a series of forehands: the marks show where you actually hit.

  • Compare it with the band. Calculate the centre of percussion with the swingweight and MGR/I calculator or place it in the module. If your marks fall above the band, lead at 12 o'clock brings it closer; if they spread sideways, lead at 3 and 9 reduces twisting. Adding lead to a racquet details what each position changes.

  • The arm first, power second. Within a few centimetres of the centre, ball speed changes little. Comfort and direction change a lot.

  • The setup, not the stroke. If the band and your marks do not overlap, it is the setup that needs revisiting. The ProSetup tuning does this on your own frame, with values measured before and after.

The sweet spot does not protect the elbow on its own: frame stiffness, string and grip size count just as much (see Tennis elbow and your racquet). It gives no extra power. It is located, it is calculated, and it is placed.

What we do not know yet

Published measurements involve few players: a few dozen at most for studies in playing conditions. Brody himself thought it would take hundreds of players to say whether a heavier racquet slows the swing enough to cost speed. Models, including the module's, describe the order and relative position of the zones, not their position to the centimetre on a given racquet. For that there is only one method: measure the racquet.

Sources

  • Hatze, H. (1976). Forces and duration of impact, and grip tightness during the tennis stroke. Medicine and Science in Sports, 8(2), 88-95.

  • Brody, H. (1981). Physics of the tennis racket II: The "sweet spot". American Journal of Physics, 49, 816-819.

  • Hennig, E. M., Rosenbaum, D., Milani, T. L. (1992). Transfer of tennis racket vibrations onto the human forearm. Medicine and Science in Sports and Exercise, 24(10), 1134-1140.

  • Cross, R. (1998). The sweet spots of a tennis racquet. Sports Engineering, 1, 63-78.

  • Li, F.-X., Fewtrell, D., Jenkins, M. (2004). String vibration dampers do not reduce racket frame vibration transfer to the forearm. Journal of Sports Sciences, 22(11-12), 1041-1052.

  • Allen, T., Haake, S., Goodwill, S. (2011). Effect of tennis racket parameters on a simulated groundstroke. Journal of Sports Sciences, 29(3), 311-325.

  • Choppin, S., Goodwill, S., Haake, S. (2011). Impact characteristics of the ball and racket during play at the Wimbledon qualifying tournament. Sports Engineering, 13, 163-170.

  • Ikenaga, M. et al. (2020). Influence of ball impact location on racquet kinematics, forearm muscle activation and shot accuracy during the forehand groundstrokes in tennis. Proceedings, 49(1), 89.


Comments


bottom of page