Measuring your racquet: what a scale can tell you, and what takes a pendulum
Updated: 7 hours ago
Every racquet setting starts with a number: the mass before adding lead, the balance before touching the handle, the swingweight before matching two frames. That number is not the one on the spec sheet. The spec sheet gives the target for the series; your racquet sits a few grams and a few points away from it, and it is your racquet you play with. Two of those numbers can be read with a scale. The others require the racquet to swing.
What a scale can tell you
Mass. A kitchen scale accurate to the gram is enough. Write down the state of the racquet: strung or not, with or without an overgrip, with or without a dampener.
Balance. On the edge of a ruler you get it to within half a centimetre. With two scales, you gain an order of magnitude:
Lay the racquet flat on two supports, one on each scale.
Measure the distance from each support to the butt of the handle: a for the first, b for the second.
Read both scales: F1 and F2.
Mass = F1 + F2
Balance = (F1 × a + F2 × b) ÷ (F1 + F2)
This is a plain balance of moments: no hunting for the tipping point, no trusting your eye. Precision depends only on the scales and on where the supports sit. To convert the result into points head light or head heavy: balance in centimetres and in points.
What a scale cannot tell you
Swingweight is the racquet's inertia about an axis 10 cm from the butt: what your arm has to set in motion on every stroke. Two racquets with the same mass and the same balance can have different swingweights, because the mass is not spread the same way on either side of the centre of gravity. No weighing can see it. The racquet has to swing, and the swing has to be timed.
Hung from that axis, the racquet behaves like a pendulum. Its period T, the time of one full swing there and back, gives the inertia:
SW = m × g × d × T² ÷ 4π²
with m the mass in kilograms, g = 981 cm/s², and d the distance from the axis to the centre of gravity in centimetres (the balance minus 10). The result is in kg·cm², the unit of swingweight.
Example: 320 g, balance at 32.5 cm, so d = 22.5 cm. A period of 1.337 s gives 0.32 × 981 × 22.5 × 1.337² ÷ 39.48 ≈ 320.
Why a hand-held stopwatch is not enough
Swingweight follows the square of the period: a 1% error on T becomes a 2% error on the result. Ten swings timed by hand take about 13 seconds, and a finger is a tenth of a second off at the start and again at the end. That is close to 0.8% on the period, so 1.5% on the swingweight: about five points, when two matched racquets should stay within one or two points of each other.
Balance matters too, because it goes into d. One millimetre of error on the balance moves the swingweight by more than a point. And whatever holds the racquet has its own inertia, which has to be known to take it out of the calculation.
Twistweight, the inertia about the long axis of the frame, is measured the same way, by letting the racquet turn about itself. It is more than twenty times smaller than swingweight, and so are its differences: by hand, it is out of reach. What it says about stability: twistweight and recoilweight.
Why measure your own racquet
The published values of a retail frame are targets, not readings. Nobody takes a racquet off the line to give it its real mass, balance and swingweight: that is ordinary industrial practice, and the player inherits the gap. Measuring it is doing the step that was skipped.
Three cases where measuring changes the decision:
Before adding lead. Know where you start, then check that the lead did what you expected. The swingweight and MGR/I calculator predicts the effect; the measurement confirms it.
To match two racquets. "The same model" does not mean the same racquet: matching two racquets.
To follow a frame over time. A restring with another string, an extra overgrip, a new handle: every change can be read.
The Matcheur measuring kit
These three cases are why the workshop built its own instruments, and why it now offers them to players. Matcheur Equilibrium reads mass and balance on two scales, with a bubble level to set it flat. Matcheur Inertia times the swing and gives the swingweight, then the twistweight; it then calculates recoilweight, spinweight and MGR/I, keeps the history of every racquet, and simulates added weight before it touches the frame. The whole kit fits in a tennis bag.
Try the kit online: the demo puts Inertia and Equilibrium on a tennis court, with the device's own screen in your browser, a step-by-step walkthrough and coach scenarios.
Frequently asked questions
Should the racquet be measured strung or unstrung?
Both work, as long as you always note which. A string weighs around 16 g, spread far from the butt: it moves the balance about one centimetre towards the head and raises the swingweight noticeably. Matcheur racquet settings are given unstrung.
Can a phone app measure swingweight?
It can time a swing with the sensors of a phone fixed to the frame. But the phone adds its own mass far from the axis, and the calculation still depends on the balance you give it. The order of magnitude is right; the difference between two racquets, rarely. What really sets the devices apart: swingweight machine, which one to choose.




Comments