Swingweight machine: pendulum, workshop station or app, which one to choose?
Updated: 8 hours ago
Measuring swingweight means letting the racquet swing and timing the motion. Every device does that, from a pendulum built in a garage to a workshop station. What sets them apart happens around it: the mass and balance they take into account, the holder they remove from the calculation, how consistent their readings are, and what you can do with the number once it is on the screen.
The physics of the measurement is explained in measuring your racquet. This article is about the tool: how to choose one, and what to ask of it before you trust it.
Three families of devices
The pendulum and a stopwatch. An axle, a holder and a stopwatch. It is the simplest tool, and it gets the order of magnitude right. Timed by finger, it is off by about five points: enough to tell whether a racquet is easy to swing, not enough to match two. A light gate that counts the swings solves the timing, but not the rest: a balance read somewhere else, the holder's inertia, the position of the axle.
The workshop station. A frame that sits on a bench and measures mass, balance and swingweight, sometimes twistweight. It is the tool of shops and stringers who handle dozens of racquets a week. Well calibrated, it is accurate. It is also built to stay on the bench: it does not come to the club, or to a tournament.
The phone app. The phone is strapped to the frame and its sensors follow the swing. It is the most accessible way in, and the order of magnitude is right. But the phone adds its own mass far from the axle, and the calculation relies on the balance you type in. The difference between two racquets, the one that matters, is rarely reliable.
What really matters
Repeatability, before resolution
A decimal on a screen is not precision. A display that reads 321.4 claims a tenth of a point. What you need to know is what it reads the second time, then the third. If the same racquet gives 321.4, then 318.9, then 323.0, the decimal says nothing: the device measures to within four points, and the display hides it.
The arithmetic shows it. Swingweight follows the square of the swing period. For a racquet at 320, a tenth of a point is 0.03% of the result, so 0.015% of the period: about two tenths of a millisecond on a 1.34 s swing. And since one millimetre of balance moves the result by more than a point, that same tenth requires knowing the balance to better than a tenth of a millimetre. Displaying the decimal means promising both, on every reading.
The test takes two minutes: measure the same racquet four times in a row, taking it out of the holder between readings. The gap between the highest and the lowest value is the device's real precision. To match two racquets, which should stay within one or two points of each other, that gap has to stay under a point.
Mass and balance, taken in the same session
Swingweight is calculated from the period, but also from the mass and the distance between the axle and the centre of gravity. A device that asks you to type in a balance read elsewhere inherits the error of that reading: one millimetre off, and the result slides by more than a point. Mass and balance have to be taken to the gram and to the millimetre, on the same racquet, in the same state, just before the swing. To read balance in centimetres and in points: racquet balance.
The holder and the axle, taken out of the calculation
Whatever holds the racquet swings with it. Its inertia has to be known and subtracted, and the device has to be checkable against a reference. Ask how that calibration is done, and whether you can redo it yourself.
The position of the axle matters just as much. Swingweight is given about an axis 10 cm from the butt. If the butt sits five millimetres too high or too low, the result moves by about seven points on a typical racquet. A good holder places every racquet in the same spot, adult or junior, strung or not.
Twistweight, on a second axis
Twistweight is the inertia about the long axis of the frame: its resistance to twisting on an off-centre ball. It is more than twenty times smaller than swingweight, and so are its differences. It cannot be derived from the other measurements: the racquet has to turn about itself, timed with the same rigour. A device that only measures swingweight leaves out half of stability. What it tells you: twistweight and recoilweight.
What the device does with the number
A swingweight on its own is of little use. What is useful is the difference: before and after adding weight, between the two racquets of a pair, between today's racquet and the same one six months from now. A useful device keeps readings per racquet and compares them.
It should also help you decide before anything goes on. The effect of lead on swingweight can be calculated: ΔSW = m × (d − 10)², with m the added mass in kilograms and d its distance from the butt in centimetres. Three grams placed 60 cm from the butt add 0.003 × 50², or 7.5 points. The swingweight simulator does that calculation for any setup; the measurement tells you where you start, then checks where you land. Where to put the lead: adding lead to a racquet.
From mass, balance and swingweight come recoilweight and MGR/I. If the device gives them, they should come from readings taken in the same session, not from values typed in by hand.
Where it will measure
A coach measures at the club, a parent follows the racquets of a junior who keeps changing size, a tournament player checks a pair before the match. For them, a device that stays on the bench rarely measures at the right moment. A self-contained, rechargeable device that sets up in a few minutes and travels in a tennis bag measures where the racquet is played.
The Matcheur Inertia + Equilibrium kit
The workshop designed its own instruments to meet each of these criteria, and now offers them to players.
Matcheur Equilibrium reads mass and balance on two scales, with a bubble level to set it flat: balance to the millimetre, from 25 to 38 cm.
Matcheur Inertia gives the swingweight, then the twistweight, and calculates recoilweight, spinweight and MGR/I from those four measurements.
Repeatability checked at the workshop: four successive readings of the same racquet stay within 0.3 swingweight points.
The racquet holder centres itself on the handle: every tennis racquet, adult and junior, strung or unstrung.
300 readings kept with the racquet's name, the player, the date and your notes. CUSTOMISE simulates a weight change before it touches the frame; COMPARE puts before, planned and after side by side.
Two self-contained, battery-powered devices, recharged through USB-C, made to order at the workshop in Normandy. The kit fits in a tennis bag.
Try the kit online: the demo puts Inertia and Equilibrium on a tennis court, with the device's own screen in your browser, a step-by-step walkthrough and coach scenarios.
Frequently asked questions
What precision do you need to match two racquets?
Two matched racquets stay within one or two swingweight points of each other. The device therefore has to measure clearly better than that gap: under a point, in repeatability. The full method: matching two racquets.
Do you need a machine to add lead to your racquet?
To put the lead on, no. To know what it did, yes. The calculation predicts the effect of added weight from the racquet as it is supposed to be; only a measurement tells you where you actually start, and confirms the result once the lead is on.
Can you build your own pendulum?
Yes, as long as you deal with every source of error: a friction-free axle 10 cm from the butt, a holder whose inertia you know, a balance read to the millimetre, and several swings counted by a light gate rather than a finger. The calculations and their pitfalls are in measuring your racquet.
Is a swingweight machine only for stringers?
No. It is for anyone who needs to compare: the coach who follows a group, the parent whose child changes racquet every season, the tournament player who keeps a pair, the player who tunes their own racquet. A stringer measures many racquets; they measure the same ones often, and what interests them is the change over time.




Comments